It is shown on the nameplate that was manufactured in 1990.
Simson S51B renovation
One of my friends who helped me a lot, brought me a scooter because it was a lot of electrical problems ...
It is shown on the nameplate that was manufactured in 1990.
The reinforcement bracket was broken seat behind the petrol tank.
The rear seat is only half took a factory ear.
Tank dismantled in.
The rear seat's attachment is broken
laid bare
The voltage regulator relay and the index unit
Dismantled: the condenser side is quite blossomed ...
Before wiring:
dismantled
Dismantling of old grain terminals
During km h ... Within the hour I found a broken light bulb ... I think that's why it is always the téphette spiral.
Re-wired the first light (splicing was full).
New grounding lug was the turn signal is Twitter.
Old insulated socket blade fuse holder fuse replaced.
The old index dome were damaged and the color was pretty dull, so I got new ones.
A
broken seat mounting bolts polished,
the rear seat compartment as well ...
Then welded.
The engine block had released the oil mud. Brigéciol this is one of the best solution.
I scrubbed with a brush and a bucket over in less than 2 days ...
Old wires everywhere ...
During the engine is small puddle formed in the quench solution.
The wheels have also been washed down ..
The old labels I just picked covers hot-air blower,
but the glue of course there was ...
A few hours scrubbing paint thinner and gasoline lo and behold ...
The lamp is saruit be a bit of time, and are guaranteed to come into contact with.
Coatings thinner washing off one last time, prepared for painting.
The meeting also received a new twist, because such a rusty sh*t No. I do not return ...
The entire engine high pressure cleaner been washed off, not to have any dirt anywhere.
Items prepared for painting
Painting started ...
Because welded or worn, rusted parts of the body has been blown matt black paint.
The rear fender and the bottom of the frame also has been sanded down and repainted, which was rusty.
Painted elements.
Front fender preparation:
The fender holder clamps were also washed off.
Tank mounted return.
The inscription was pretty clean. Before the letters were black oily dirt.
Front
fender rust Sanding
Painting of ...
The rear trunk was leaning quite apart, this is a relatively straightened.
The washed block looks much better.
Like the fender repainted.
Seat back and side-mounted battery.
A temporary battery tried indexes, etc. to the charge.
Blanks from the telescope still not very impressed with ...
These also bought him new ones.
Almost else :)
I replaced the carburetor gasket, because it cut paper one home, but the leaked ...
Igniting, lighting tested :).
Has been quite good-looking ..
It's got a new fuel hose and an extra fuel filter.
It
is a new index in the back shell
The end of the clutch lever was broken down and the cable is broken ...
I also switched it.
The government has weathered the middle of the plastic coating, I am more ripped.
It also has been painted metallic blue.
The end result was quite nice :).
The new clutch lever and cable pair.
19.05.2017.