Adobe house renovation – Back garden and gate

The back garden was virtually useless due to the bush that was there.

Thanks to the days of fire lightning, I found a simple solution to the bushing ...

Such a bushy, bushy, bushy back garden ...

(Pure primrose ...)

Not to mention vinegar trees and fallen fences.

With a small waste branch, empty cement bag and all sorts, it had been difficult to ignite.

First, the part near the fence was lighted, sprinkled from the outside.

So much left of it, which could be further reduced by a branch cutter one by one.

Everything under the bush was everything: Bricks, glass, plastic, foil, wire, beer box, etc ...

Here's the terrain.

These nymph vinegars are everywhere...

The big vinegar point stands in the middle of the road...

The next day is rubbish cleaning.

The vinegar was sentenced to death by a chainsaw.

As it turned out, at the end of the garden there was another gate sometime...

It was better to see :).

Here the vinegar was dug up.

The columns say they were a bit fired ...

Of course, the angle grinder and the welder helped

I cut the column from one side, I set the vertical line and used it to backheat...

So it became more beautiful ...

(Anyway there is a concrete siding along the fence line so I did not replace the column)

This is my other problem here: Well ring in the middle of the road... There should be a truck here...

And I'll be thinking about the 5 kilos hammer :).

Hammer, Well Ring 1: 0.

2:0

3:0

4:0

The bottom of it is where it is. I'm not picking it up yet.

4:1.
Well, I picked it up later.

If I have already had such a place, I also brought the soda here because it is much easier to carry it from top to bottom :)

Of course, this had to be the place for the truck first. It had to be carved 1 meter away from the cobblestones ...

That's how the truck came.

So the freshly cleared soil was well-flattened. The concrete slab shown in the picture is for example It was crushed...

The location of the new fence column was following (strictly inside the sandiap because I did not cut it):

I invented a new sport while: Concrete delivery: D

The column had to be full concrete for a full wheelbarrow (not full yet).

It stands for the new column like the stakes :)

Finally, it was made with a small fence wire:

I'll leave the concrete a little longer ...

I made two hollowed-in hammocks ...

I was welded to the gate after marking

Then he got some paint.

The other side of the gate must be reinforced by the column, because the weight of the gate would smooth...

The old gate is in a bad condition, just like the column.

While I was breaking the fence, I found the old column ...

I dig a hole and it will be restored to its place.

This closed profile will hold the column when the gate opens.

It was welded

At the bottom a piece of pipe was welded to better cling to the concrete.

New hinges are also ready.

The column is aligned with string and water level.

Everything has been set to vertical.

Its bottom is cast concrete.

The next day, he was buried with earth so that after watering the water would remain in this sunny day.

The larger gate was replaced by another because it was in a bad state.

A small piece was used to equalize the size difference.

Unfortunately this gate is a bit curved, but at least the back of the garden can be closed.

<< Back <<