Ma sikerrel portoltam az National Instruments 4050 PCMCIA DMM-hez gányolt gyári példaprogramokat egy Linux kernelmodullá.

Kód a szokásos helyen a googlekódon figyel:
http://code.google.com/p/ni4050/

Nem bírhattam ki hogy ne hegesszek hozá valami GUI-t Qt-ban természetesen:

When you facing something similar compile error, make sure that you have been defined the CONFIG_MTD_DEVICE in your config header nt just the CONFIG_CMD_MTDPARTS.

If you want to use your Altera USBBlaster with urjtag without root privileges you should add the following to the
/etc/udev/rules.d/52-altera-usb.rules files.


# USB-Blaster
SUBSYSTEM=="usb", ATTRS{idVendor}=="09fb", ATTRS{idProduct}=="6001", MODE="0666"


Credits goes to turul64

Miután a marsjáró kb. 3 hónapja áll a jólnevelt blútúszos távirányítósautó státuszában, épp idejét láttam annak hogy nekiálljak valami ügyes navigátort hegeszteni hozzá.

Read more...

I have recently got a Pinnacle Showcenter SC1000 as a gift from one of my friends.

The peripherials made me intrested, so I have disassembled it to check the internals:

It features the following stuff:
- Sigma Designs EM8551 Soc (datasheet here)
- RJ45 ethernet connector powered by an Davicom DM9000E
- 2 * 8 MB RAM ARC4X16S4K3VF-55
- 2 * 2 MB Flash AM29LV160DB
- 8 MB RAM dedicated for the MPEG codec
- wide range of video output connectors (SCART, SVideo) unfortunatelly nothigng high definition
- PCMCIA slot
- an unpopulated IDE connector
- two fully featured unpopulated serial ports
- and an unpopulated 20 pin header. At first I would bet that it is a JTAG connector, but it isn't.

Read more...