DJI Phantom 1 SR6 transmitter teardown 

I have not found any info on the web about this topic, so I was curious what RF frontend did they used.



Solution was obvious: they have used the same as they used in the receiever: the CYRF6936.

I was hoping for having some UART to hook up an Arduino to get trainer output, but I had to get disappointed.

The lower 5 pin connector is the ICE connector of the Nuvoton MINI54ZAN with:
VCC, ICE_DAT, ICE_CLK, !RESET, GND, GND

And the 3 pin is:
P2.3, GND P2.4
[ hozzászólás ] ( 22 megtekintés ) [ 0 trackbackek ] permalink ( 3.1 / 230 )

<< <Előző | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | Következő> >>

 
számláló