Yes someone welded a ovoid chainring to his cowrushing bike :D

Put the Igo to the Navitel folder on the flash.
Rename Navitel.exe to Navitel.old.exe
Rename Igo.exe to Navitel.exe

Put the following to the sys.txt:
https://gist.github.com/martonmiklos/6f35582765ecb1957ab7d66b79c23e12

I have bought a sunken PH1 around a year ago, managed to get it fly, but it is not able to see the GPS signal properly.

I have hooked up the board to my saleae and I have wrapped this tool to read the Saleae logic analyzer output CSV:
https://github.com/aanjhan/ubx

It turned out that it see some satellites, but the link quality is very poor: CNO (Carrier to Noise ratio) was mostly 0 and sometimes 28-30.

So I have replaced the ublox receiver module (to an uBlox 6T), it see more satellites, with better CNo (27-33) but still no signal lock in the system.

I have ordered today a ANT1575-2540A from the TME and we will see.
There is a ALM-1912-BLKG in the antenna path, but I have not been able to source it yet. And my hopes to the antenna is pretty high :D.

Schematic diagrams for the Tyco Mutator RC car (gathered from the FCC site).

Back in the days when I was kid I would give a lot for these docs when my car broke down. (It is waiting since then for the BL conversion...)



Tyco Mutator TY-W1237 schematics



Tyco Mutator TY-W2310 schematics

My father bought a second hand high power lamp powered by 3 18650 cells.

Unfortunately after installing the batteries there were no way to turn it off.

I have opened up with: "worst case I will put a switch to it" in my mind.

The circuit inside is simple: basically an SOT-23-6 IC marked with 819L 48 a power P fet in SO8 package and some current limiting resistors:



After doing some google fu I ended up on this website:
http://go-radio.ru/remont-nalobnogo-fonarya.html

It turned out that the IC is a Shenzhen Fuman Elec FM2819 The datasheet is only available in chinese, but pushing through the google translate did not helped either.

I have noticed one thing: there were an unpopulated 0603 place parallel with the pushbutton. The russian blog mentioned above that he have had found a cap in the box fallen from the same place. I have followed his advice put a 0603 100nF cap there and now the lamp works as expected.