Today building the daily OpenWRT snapshot for my NSLU2 failed with an error:
Read more...
../include/obstack.h:153: error: attempt to use poisoned "bcopy"
Read more...
Today building the daily OpenWRT snapshot for my NSLU2 failed with an error:
Read more... I have stucked several times with touchscreens and Qt.
My problem's main reason is that I compiled the Qt and tslib outside the openembedded, because I did not liked the Openebmedded's Qt building method. (Build Qt twice once cross compiled, once for the host.) I have stucked several times in the following situation: ts_calibrate calibrates, and ts_test works fine, but my Qt app cursor's moves inverse, or it too sensitive or whatever. Well it seems to be that the various tslibs do not like another, and their configuration files are not interchangable. And the best one: Qt app likes to work only with the tslib with what it had been compiled. So if you ran into the similar problem: Clean up all your existing tslib stuff:
And place your own compiled tslib's binaries, and plugins there. After then set the following enviroment variables properly of coures:
Run ts_calibrate And finally run your Qt app with -qws option. Van pár feladat aminek a végrehajtását szeretem elkerülni a számítógépemen. Ilyen például a Qt fordítás. Baromi sokáig tart, és végig üvegeli a a gépet. A gentoos "compile 5 hours to run 5 ns faster" filozófia pedig eddig még nem érintette meg a lelkemet.
Beágyazott szuttyok esetén nem mindig adatik meg az a lehetőség, hogy bináris csomagot használjon az ember. Így volt ez most is, amikor egy Friendlyarmos panelre kellett Qt-t varázsolnom. Az openembedded sajnos csak úgy képes Qt-t fordítani, ha az először lefordítja az x86-osat, majd az embeddedet. Ezt el kívántam kerülni, ezért 2 napig reszeltem a bitbake és az mkspec fájlokat, de végül feladtam. Képtelen volt desktopon futó qmaket összehozni, így végül ezt a leírást használtam: http://billforums.station51.net/viewtop ... p;p=44#p44 Illetve megspékeltem az opciókat ezekkel:
A fordítás egy Intel T7400 C2D-n kevesebb mint 20 perc alatt lezajott. Öröm van a köbön. I have managed to generate a pad layout picture for the IBM STB02051Set top Box Soc from this BSDL file.
I will desolder this CPU from my Amino Aminet 110 to trace the JTAG pins. I have generated the pinout image for the Broadcom BCM6348 BGA package:
The input source was: http://www.f-x.fr/wikini/wakka.php?wiki=Bcm6348PinOut The generation was done with a small Qt program: http://balubati.atw.hu/blog/images/pinoutviewer.tar.gz A pinout image for a smaller package can be found here: http://pudeev.livejournal.com/37410.html |